2-36
IM DL950-02EN
2.9 Configuring the Monitoring of CAN and CAN
FD Bus Signals (/VCE option)
This section explains the following settings for monitoring CAN and CAN FD bus signals.
Items Common to Scope Mode and Recorder Mode
• Turning waveform input or and off
• Data frame reading settings (all sub channel settings, factor and offset settings of all sub
channels, port settings, definition file loading)
• Individual sub channel scales
• Display group
• Setting and executing one-shot output
• Scaling of all sub channels
• Sample rate and sample interval settings
► “CAN and CAN FD Bus Signal Monitoring (/VCE option)” in the Features Guide
Channel Setup Menu
1.
On the waveform screen’s
MENU
, tap
VERTICAL
>
CH
, or press
CH
. A channel setup menu
appears.
(You can also tap the channel information display area at the top of the screen to display the
channel setup menu.)
2.
Tap a channel you want to configure, or select it using the jog dial or up and down arrow keys.
See “Setting the Scale and
Display Groups.”
Turns the waveform
input on or off
Displays the second
page of the menu
See “Configuring Data Frame
Reading Settings.”
Set the scaling of all sub
channels
(All SubChannel Auto,
All SubChannel Default)
Executes one-shot output
Channel setup menu (2/2)
Channel setup menu (1/2)
See “One-Shot Output
Setup.”
Set the sample rate.
(Scope mode)
Set the sample interval.
(Recorder mode)
► sec. 2.1
Displays the first page of
the menu
