5. CHANGING SETTINGS
IM 2493AAA-1
12
Changing the Analog Output Settings
When you reach the ‘out1’ (or ‘out2’ or ‘out3’) display, press Set and the value of
HI will be displayed. Pressing Set again will cause the first digit to begin blinking.
To move to the next digit press Next. Next will move you through all four digits
and back to the first one, if necessary. You can increment the value of the
blinking digit by pressing Inc. Once a digit has reached 9 (nine) it will go to 0
(zero) on the next press of Inc.
When you have set the digits as you want them, press Set. The decimal point
will now be blinking. You can then move the decimal point to the right by
pressing Inc. Once it has reached the last position it will jump to the first position
on the next press of Inc.
Pressing Set again will bring you to the Multiplier (Kilo) setting. In the leftmost
digit you will see a blinking ‘ |- ‘ and if the multiplier light is on it will also blink.
You can change the setting by pressing Inc.
