4-4
IM DLM3054-03EN
4.3 Video Signal Output (VIDEO OUT)
CAUTION
• Connect the cable after turning OFF this instrument and the monitor.
• Do not short the VIDEO OUT connector or apply external voltage to it. If you do, the
instrument may malfunction.
French
ATTENTION
• Connecter le câble après avoir mis cet instrument et le moniteur hors tension.
• Ne pas mettre le connecteur VIDEO OUT en court-circuit et ne pas y appliquer une tension
externe. Si vous le faites, l’instrument risque de ne pas fonctionner correctement.
Video Signal Output (VIDEO OUT) Connector
You can use video signal output to display the instrument’s screen on a monitor. Any multisync monitor
that supports XGA can be connected.
VIDEO OUT (XGA)
6
11
1
5
15
10
D-Sub 15-pin receptacle
Pin No.
Signal Name
Specifications
1
Red
0.7Vp-p
2
Green
0.7Vp-p
3
Blue
0.7Vp-p
4
−
5
GND
6
GND
7
GND
8
GND
9
−
10
GND
11
−
12
−
13
Horizontal sync signal
Approx. 48.3 kHz, TTL negative logic
14
Vertical sync signal
Approx. 60 Hz, TTL negative logic
15
−
Connecting to a Monitor
1.
Turn off this instrument and the monitor.
2.
Connect the instrument and the monitor using an RGB cable.
3.
Turn on the instrument and the monitor.
Note
• An RGB video signal is always running through the VIDEO OUT connector.
• The monitor display may flicker if you place the instrument or some other device close to it.
• Depending on the type of monitor, parts of the instrument’s display may be cut off.
