YOKOGAWA Daqstation DX2000, User Manual

Page: 317 / 366

11-19
IM 04L42B01-01E
Troubleshooting
1
2
3
4
5
6
7
8
9
10
11
12
13
App
Index
Warning Messages
Code Message Ref. Section
600 Measured data and Settings have been initialized. –
601 Measured data have been initialized. –
610 This usernema is already registered. See section 8.2.
611 There is no user who can enter to the SETUP mode. –
612 Please acknowledge all active alarms before stopping this record. This message appears if you try to stop
recording when there is an alarm that the alarm
ACK operation has not been performed on. You
can either stop recording or perform the alarm
ACK operation and then stop recording. See
the See sections 6.3 and 6.4 in the advanced
security manual.
614 Calibration settings are reset because of range setting change. See section 3.9.
615 Noise may influence measurement in test mode. See section 3.1.
For information about messages whose codes are in the 700s, see page 11-5.
System Errors
Servicing is required when a system error occurs. If this happens, contact your nearest
YOKOGAWA dealer for repairs.
Code Message
901 ROM failure.
902 RAM failure.
910 A/D memory failure for all input channels.
921 Channel 1 A/D calibration value error.
925 A/D calibration error.
930 Memory acquisition failure.
940 The Ethernet module is down.
950 Incorrect number for the A/D calibration.
951 Failed to write A/D calibration value.
11.1 A List of Messages