iv
IM 701988-01E
Safety Precautions
This product is designed to be used by a person with specialized knowledge.
The following safety precautions must be taken to ensure safe and correct
operation of the instrument. The instrument’s functions may not work if used in
a manner not described in this manual. YOKOGAWA bears no responsibility for,
nor implies any warranty against damages occuring as a result of failure to take
these precuations.
This manual is part of the product and contains important information. Store
this manual in a safe place close to the instrument so that you can refer to it
immediately. Keep this manual until you dispose of the instrument.
Safety Symbols and Wording Used in This Manual
Handle with care. Refer to the user’s manual or service manual. This
symbol appears on dangerous locations on the instrument which require
special instructions for proper handling or use. The same symbol appears
in the corresponding place in the manual to identify those instructions.
French
À manipuler délicatement. Toujours se reporter aux manuels d’utilisation
et d’entretien. Ce symbole a été apposé aux endroits dangereux de
l’instrument pour lesquels des consignes spéciales d’utilisation ou de
manipulation ont été émises. Le même symbole apparaît à l’endroit
correspondant du manuel pour identifier les consignes qui s’y rapportent.
Important Warnings and Information for Users
For safe operation and proper use of the instrument’s functions, please heed the
following warnings and safety precautions.
W WARNING
• Take care to avoid electric shock when connecting the probe to the
circuit under test.
• Never disconnect the probe from the oscilloscope while connected to
the circuit under test.
• Do not allow the probe to become wet, and do not handle the probe with
wet hands. Doing so can result in electric shock.
• Before connecting the probe’s lead set to the circuit under test, confirm
that the oscilloscope is properly grounded, and that the probe’s cable is
connected to the oscilloscope’s logic signal input port.
• Ground the Oscilloscope
Be sure to implement the oscilloscope’s protective earth ground.
• Maintain Nondestructive Input Voltages
Do not apply a voltage between input and ground exceeding ±42 V
(DC + ACpeak).
• Do not use the probe in humid locations
To avoid electric shock, never use the probe in areas of high humidity.
