ENGLISH
13
STEAM IRONING
1.
Open the reservoir lid and fill it with water to the “MAX” level – in order to check water level, the
iron must be held in vertical orientation. Be careful not to wet other parts of the iron while pouring
water into the reservoir.
2. If you want to iron especially wrinkled fabric use the spray to dampen it a bit.
3. Plug the unit in and put the temperature control knob in the
“••” or “•••” position appropriate for a
given fabric.
4. Place the iron on the base. If you want to iron cordless, put the base lock in the position.
Otherwise, put it in the position. When ironing cordless, place the device on the base every
about 35 seconds.
5. Wait for the heating indicator to turn off and the readiness indicator to light up green. Commence
ironing. Move the steam generation switch to the right to enable constant steam generation.
6. As needed, use the steam shot functionality in places with especially stubborn wrinkles.
7. After finishing work, turn the unit off, unplug it and wait for it to cool down completely. To achieve
best results allow the ironed item to cool down completely. This will prevent new creases during
folding or putting on clothing.
II. VERTICAL IRONING
1.
Open the reservoir lid and fill it with water to the “MAX” level – in order to check water level, the
iron must be held in vertical orientation. Be careful not to wet other parts of the iron while pouring
water into the reservoir.
2. Plug the unit in and pu
t the temperature control knob in the “•••” position.
3. Place the iron on the base. If you want to iron cordless, put the base lock in the position.
Otherwise, put it in the position. When ironing cordless, place the device on the base every
about 35 seconds.
4. Wait until the heating indicator goes off and readiness indicator turns green. Hover the iron min.
10 cm over the fabric to avoid burning it and use the steam shot functionality every few seconds.
5. After finishing work, turn the unit off, unplug it and wait for it to cool down completely. To achieve
best results allow the ironed item to cool down completely. This will prevent new creases during
folding or putting on clothing.
CLEANING AND MAINTENANCE
WARNING:
For the unit to work properly clean it after each use.
The unit will be hot after use. Exercise caution to avoid burns.
Never submerge the unit in water.
Do not use erosive cleaning agents or abrasive tools such as scouring pads or wire brushes.
1. Unplug the iron. Hold the hot iron over a sink and move the steam generation switch to the left to
enable the self-clean functionality. A hot water will come out of the soleplate.
2. Leave the iron to cool down completely and then empty the rest of water from water reservoir over
a sink.
3. Wipe the iron and its soleplate with a soft, damp cloth. Do not wipe the electrical contacts.
4. Carefully dry the unit off.
