- This appliance is only intended for clipping human scalp hair. Do not use it for any other
purpose.
The display
- When the
appliance
is charging, the battery charge percentage and the battery symbol
goes on to indicate that the appliance is charging.(Fig. 2)
- The remaining battery capacity is indicated by the battery charge percentage shown
on the display.
Battery fully charged
When the battery is fully charged, the battery charge percentage lights indicated
shown 100
Battery low
When the battery is almost empty, The battery symbol starts to flash.(Fig. 3)
add lubrication reminder
We advise you to clean the appliance after every use.
When the add lubrication
reminder symbol flashes to remind you Must add the
lubrication on the knife.(Fig. 4)
locking function symbol
The locking function prevents the product accidentally closing during use.
Enable locking function
Press the on / off button 3 seconds to enter the lock mode, And then the lock symbol
will light up on the screen. (Fig. 5)
Unlock the appliance
Press the on / off button for 3 seconds.
The symbol of the lock appliance is extinguished,And now it can be used to close the
appliance.
Charging
The suitable voltage for the appliance charger is 110V-240V~ 50Hz/60Hz
Do not charge the appliance for more than 24 hours
Charging takes approx 2 hours.
When the appliance is fully charged,It has an operating time of 200 minutes.
1 Make sure the appliance is switched off.
2 Put the adapter in the wall socket.The battery charge percentage and the battery symbol goes
on to indicate that the appliance is charging.(Fig. 6)
Optimising the lifetime of the rechargeable batteries.
Discharge the rechargeable batteries completely twice a year by letting the motor run until it
stops.Then fully recharge the batteries.
Using the appliance
Clipping with hair clipping comb
Note:
Make sure your hair is clean and dry.Do not use the appliance on freshly washed hair.
1 Comb your hair with a styling comb in the direction of hair growth. (Fig. 7)
2 Slide the hair clipping comb into the guiding grooves of the appliance (‘click’).(Fig. 8)
Make sure that the arms of the comb have been properly slid into the grooves on both sides.
The corresponding hair length is visible on the inside of the comb.
The appliance can cut hair to 4 different lengths(3、6、9、12mm).
3
switch on/off button to switch on the appliance.(Fig. 9)
4 Place the hair clipping comb on the scalp and move,The appliance through the hair slowly.
