13
5.8- Check the oil level ;
On the mounting position tables the oil level plug is shown. Please refer to those
tables and be sure that the oil level is correct according the mounting position. Use
a wire as shown below for checking the oil level entering from the level plug. The oil
level must be within 3mm from the plugs entering point as shown below. If you need
to adjust the oil level refer to the oil tables given on this manuel and be sure you are
using the correct oil. Observe the nameplate for the correct oil.
After checking the oil level of gear unit tighten the screws very carefully to prevent oil
leakage.
Do not mix synthetic oils with mineral which can cause serious damage on the
gear unit.
5.9- Check shaft ends and mounting faces;
Before you start to installing be sure that all the connection elements are free of oil
and dust. The output shaft may be protected by anti-corrosion oil. Please remove this
using available solvents on your market. By using this do not touch sealing lips or
painting of the housing.
5.10- Cover abrasive ambient;
If the gear unit will be placed on a abrasive ambient be sure that the output seals
are covered so that no abrasive material, chemicals or water touches the seals. Any
pressure coming from outside over the seals can cause that the out staying sub-
stances to enter the gearbox and cause serious damage to the gear unit. If pressure
or abrasive material can not be prevented from
coming over the sealing, contact YILMAZ for solutions.
Abrasive material, chemicals, water, positive or negative pressure exceeding 0,2 bar
can affect or damage the sealing lip or output shaft. Inside entering substances from
the seals can cause serious damage to the gear unit.
To avoid temperature rising in case of dust cover on the housing of the gearbox, the
housing have to be cleaned regularly.
5.11- Check accessibility to filling, breather and drain plugs;
The filling, breather and drain plugs must be freely accessible for further checking
and service.
o
o
Operating Instructions
V Series
YILMAZ REDÜKTÖR
Installing
