RPM-
Port
Vbar
Tele-
Port
Vbar
6
.
.
. 1
5
.
. .
1
U
S
B
A
d
a
p
te
r
+
Telemetry
RPM (ext. Gov.)
Ground (- receiver)
receiver throttle
BEC 5,5-8,4V (+ receiver)
Ground (- receiver)
Connections:
Master
Telemetry
Connecting the ESC to the USB-Adapter:
Telemetry:
If you use a backup-battery, please make sure, that you
power up the ESC first, before connecting the backup-
battery to the receiver. Otherwise the telemetry might not
work. The ESC sends all ESC-related data via telemetry,
such as voltage, current, capacity, BEC-voltage, RPM,
throttle percentage, PWM, BEC-temperature, warnings and
error messages. It depends on the used receiver and
transmitter, which of these data will be shown in the
transmitter.
YGE (preprogrammed):
The YGE-protocol is for example for use with
YGE TexY
(Futaba, Spektrum, FrSky, Core), MSH Brain 2 or Spirit
FBL.
Jeti ExBUS:
Please configure your receiver for using ExBUS (Not EX!)
on the E1 or E2 channel and connect the telemetry cable
(blue connector) with this channel. The telemetry in the
ESC must be set to Jeti ExBUS in the PC-Software as well.
After that, several ESC parameters can be configured in
the JetiBox menu of the transmitter. You find these settings
under “Mx” here.
Multiplex MSBv2 Addresses:
After selecting MSBV2 as telemetry protocol in the PC-
software, the addresses of the telemetry data can be
changed or disabled here.
Graupner:
After selecting HoTT V4 as telemetry protocol in the PC-
software, several ESC parameters can be configured in the
telemetry menu of the transmitter. The max PWM will be
shown as max. BEC-Temp in the HoTT telemetry, because
of the small data volume in the HoTT ESC-sensor. The
max PWM is important for many helicopters to adjust the
range of the governor.
Mikado:
By using Vbar Control with NEO it is
not
necessary to do
the mode-programming or PC-Setup. The ESC has an
Auto-Detect and sets all parameters by itself after startup.
Also the telemetry will be automatically set to Mikado, so
you can set all parameters in the transmitter. The YGE-App
has to be installed in your VBC first. This does not apply to
the use with older Vbars like Mini-Vbar or Silverline.
Adapter for using Vbar-Governor and VBC-Telemetry
(available separately):
Warranty:
Our warranty conditions are based on the European
Statuary Warranty
.
Any other requirements are excluded.
That applies in particular to requirements for damage or
injuries compensation due to malfunction or failure. For
damages to property or personal injuries and their
consequences, which developed from our supply or
craftsmanship, we do not take any liability, since we have
no control on handling and use.
YGE - Young Generation Electronics
Otto-Hahn-Str. 1A
49134 Wallenhorst
Germany
09/2020
