Yetter CAB CONTROL STRIP FRESHENER 2984-050A, Operator Manual Parts Identification, Page: 6 / 40

6
Assembly Instructions
Prepping the Toolbar
Mark the center of the toolbar. Once the center is marked, measure off of the mark half the distance of what the row spacing of
each unit will be. For example, if you are setting up the toolbar for 30” row spacing, measure off of your center mark 15” on each
side and make a mark.
A 30” layout is pictured below for reference. If you are setting the toolbar up on 20” row spacing, measure
10” on each side of the center mark and make a mark. Mark the center of the mounting plate on each strip freshener.
Installing the units
Align the marks on the toolbars where each strip freshener is to be installed with the marks on the mounting plate on the strip
freshener & use the hardware to mount each unit. If clearance issues with weldments or hinge points on the toolbar arise,
alternate parts may be required. Fold the toolbar when all units installed to check for any clearance issues.