Yetter CAB CONTROL STRIP FRESHENER 2984-050A, Operator Manual Parts Identification, Page: 5 / 40

5
2984-050-R Yetter Strip Freshener
Features:

Parallel Linkage & Pneumatic Row Unit Down Force for consistency for all field contours, soil
types, & field conditions.

Designed for use with pneumatic row cleaner to enhance strip cleanliness

Operating speeds between 6-
10mph & depth adjustment between 1”-4”

Two Shark Tooth wheels run at an angle to churn dirt for optimal seed bed preparation

Optional liquid or dry fertilizer kits are available for additional value to this field pass

Heavy Duty, Pneumatic Rolling Basket conditions the strip
BOLT TORQUE
Mounting bolts and hardware
All hardware is Grade 5 unless otherwise noted. Grade 5 cap screws are marked with 3 radial
lines on the head. If hardware must be replaced, be sure to replace it with hardware of equal
size, strength & thread type. Refer to the torque values chart when tightening hardware.
Important: Over-tightening hardware can cause just as much damage as under-tightening.
Tightening hardware beyond the recommended range can reduce its shock load capacity.
The chart below is a guide for proper torque. Use it unless a specified torque is called
out elsewhere in the manual. Torque is the force applied to the end of the handle or
cheater bar, times the length of the handle or bar.
Use a torque wrench wherever possible.
The following table shows torque in ft.-lbs. for coarse thread hardware.
CHECK HARDWARE DAILY FOR DAMAGE, WEAR, & LOOSENESS. TIGHTEN AS NEEDED