Yetter 5000 SERIES, Owner'S Manual

Page: 22 / 24

22
TROUBLESHOOTING
ISSUE CAUSE CORRECTIVE ACTION
Residue Plugging 1. Incorrect Head Angle
2. Roller Mount Tube
incorrectly installed
3. Pivot arm orientation
incorrect
4. Bearing installed
incorrectly
1. Adjust head angle to 22 – 25 degrees (see page 12)
2. Make sure the Bearing Support Tab is on the backside
of the Roller Mount Tube
3. Reposition the pivot arm so that it offsets under the
snout & not under the row
4. Make sure the side of the bearing that protrudes
outside of the cast housing is facing AWAY from the
bearing plate (each roller should spin freely by hand)
Stalk aren’t
“devastated”
1. Operating corn head too
high 1. Lower corn head until the rollers engage
Corn Head won’t
fit on head cart
1. Devastators bottom out
2. Storage stands don’t rest
in the saddles on the cart 1. Adjust top rail & saddles higher on cart
2. Make Stand Extensions for Saddle Extensions for head
cart