8
5000-023B & 5000-024B ASSEMBLY INSTRUCTION
STEP 6:
Install the push rods into the mount brackets & attach to the pivot arms using the 5/8” Shoulder Bolts. 5/8”
Washers, & ½” Jam Nuts. Use the lower hole on the arm. The washers are to be installed on each side of
the “Eye” on the push Rod. Now install the Compression Springs, Spring Bushings, & ¾” Lock Hex Nut.
STEP 7:
Attach the roller mounts to the over bearing arms, & then install the ½” X 3 ¾” Bolts, Spacers, & ½
Lock Nuts. Slide the roller mount tubes side to side as needed to clear the end of the corn head.
NOTE:
Make sure the Bearing Support Tab is on the backside of the Bearing Mounting Plate.
2 ROW ROLLER ASSEMBLY
3 ROW ROLLER ASSEMBLY
STEP 8:
Install the Shim Washers & Bearing onto each side of the Roller. Attach the Roller/Bearing assembly to
the Roller Mount Tube using ½” X 2 ½” Bolts & ½” Lock Hex Nuts. (
3 ROW ROLLER SHOWN)
NOTE:
The side of the Bearing protruding on the outside of the casting should face the Roller.
Summary of Contents for 5000-023B
