Yetter 5000-022C, Operator'S Manual

Page: 11 / 24

11
5000-022C ASSEMBLY INSTRUCTIONS
Step 7: Install the Roller Arm Mount Tube inside the clamp channel of the pivot arms using the 5000-
138 bolt bag. Do not tighten this hardware until after the rollers have been installed in Step 8 .
Step 8:
Insert the shim washer over the shaft on each end of the roller. Install the bearing over the shaft on each end of the
roller so that the side of the casting that has the bearing protruding past the housing surface is towards the roller barrel & shim
washer. Lift each roller into place, install the ½” X 2 ½” bolts & tighten the ½” lock nuts. Once the roller & bearing hardware is
fastened, spin the roller to ensure the bearing was installed correctly. If the roller was installed incorrectly, the roller will not spin
or will have drag. Slide the roller mount tube to gain clearance on each end of the corn head & then tighten the hardware.
NOTE: BEARING HOUSING SHOULD BE LUBRICATED WITH POLYUREA GREASE BEFORE USE AND THEN EVERY 100 HOURS OF OPERATION