22.
23.
ASSEMBLY
Insert the lower end of the link into the frame with
the bearing race extending washers in place.
Gently rest the link upright in the frame.
Using one hand, align the link and press the
lightly greased pivot axle (300040483) through.
This will hold the link in place while you prep the
pivot axle nut. (
NOTE: Ignore the Loctite in the
image, use grease)
05.
06.
08.
07.
Place the bearing race extender washers
(300020049) on the lower link bearings. There
should be just enough grease there to hold the
washers in place.
Lightly grease the bearing surfaces on your link.
ASSEMBLY
Insert the collet axle nut (300030287) in the
corresponding keyed hole and thread the axle
in using a 5mm allen wrench. This acts like a
headset and is meant to preload the bearings.
*Torque: 3 Nm
Grease and install the well greased lower link
collet wedge. (300040486) Tighten with a 4mm
allen wrench and finish with a torque wrench.
*Torque: 8 Nm
Your lower link pivot is now complete. Wipe any
excess grease from the pivot axle area now and
double check your torques. This is more difficult
later in the process.
Grease the main pivot collet axle (300040485),
including the threads.
09.
10.
11.
12.
Summary of Contents for SB5+
Page 1: ...OWNER S MANUAL YETISB5 ...
