26
Disassembly Tips
disassemblY
ChanGes
We strive to make the best bikes in the world.
Because of this dedication, we continually make changes to
our bikes as needed. As the bikes are improved, assembly
and setup instructions may be affected. Any amendments to
the existing Owner’s Manual can be found on our website at
www.yeticycles.com.
frame disassemblY
Use two 5mm allen keys to loosen Ti stud from
male bolt at dogbone, shock and seatstay junction.
frame disassemblY
Hammer in Fox guide pin with dead blow
hammer. Be prepared to catch female bolt as it exits the non-drive
side of the bike.
tip:
If there is any binding during the removal process, loosen up pinch
bolts with a 2.5mm allen key.
frame disassemblY
Drive the Fox guide pin the rest of the way out.
Tip: If needed use a 6mm allen wrench to help pin the rest of the way out.
frame disassemblY
Slide seatstays down and back off Ti female
stud and male bolts with 6mm allen key in-between the seatstay and
chainstay.
3
4
1
2
frame disassemblY
Use 6mm elbow allen key to take out the
16.5mm female bolt. At the same time, make sure to hold onto the
seatstay so it does not fall.
frame disassemblY
Loosen up the male bolt from the main pivot.
Stand against the drive side of the bike, and use punch to drive out
main pivot.
tip:
If binding, loosen pinch bolts on main pivot bearings.
frame disassemblY
Slide chainstay off of rear indentions.
Separate dogbone and shock.
frame disassemblY
Take 2mm allen key and back off Ti male and
female bolt from dogbone. Repeat same step for shock.
tip:
Be careful when removing shock to prevent paint blims in the
downtube.
7
8
5
6
