ZZ17-02101-B
4. Install Storage Devices
To install 5.25” HDD or CD-ROM, it
should release the 5.25” device frame
from the cabinet body first.
Take the metal slides out from
5.25"device frame, and ensure the
metal slides should be fitted with device
in position.
Press the device inward, to take the
slides in along the rails of drive bay.
Fasten by (2) screws on front side.
To install 3.5”HDD in the 5.25”drive
bay, the metal shield could be
screwed in the front end for better EMI
result.
ZZ17-02101-B
5.
Install motherboard &
add-on-cards
Install I/O shield (putting from inside
of case).
Finding correct mounting hole for
M/B, screw in standoffs. Fasten M/B
with the screw
.
Install add-on-cards.
6. Cooling Fan mounting
Front mounted: Fasten 12cm fan from
outside of chassis by screw. Air flow
out is stronger suggested.
Rear mounted: Fasten 9cm fans from
outside of chassis by screws. Air flow
in is stronger suggested.
Side mounted: Fasten 9cm fan from outside of chassis by screws. This
vents could reserved as air flow in, no fan required. However, system
integrator could re-build the air flow depends on system's configuration. A
cooling fan could be installed in side cover, please watch out its cable
routing when side cover assembly.
7. Routing cables
8. Close the chassis
Close the door. Snap in front panel without screw.
