IT IS VERY IMPORTANT
TO READ THESE
INSTRUCTIONS
THOROUGHLY
BEFORE
LIGHTING
THE STOVE
The knob for ignition and power control is located on the lower right hand side of the
stove.
If the Flame Supervision
Devise Actuating
Flame (the Pilot Light) is extinguished
either
by intention
or not, no attempt
should be made to relight until 3 minutes
have elapsed.
(i) Igniting the permanent pilot light
1
Depress control knob fully.
2
Whilst depressed,
turn knob sharply 90 degrees anticlockwise to 'PILOT'
setting
Repeat until pilot light is visibly lit, this may take several atempts.
2
With control knob at 'PILOT'
setting, turn in an anti clockwise direction to 'LOW'
setting.
Important:
Immediately
after lighting,
the stove must be left on a maximum setting for
five minutes in order to warm up the chimney.
2
Output
can be increased, by turning the control knob progressively in a clockwise
direction
until the desired level is achieved, up to a maximum as shown by the
'HIGH'
symbol on the control panel
.
1
From any heat setting, depress control knob fully and turn clockwise to 'PILOT'
position.
(v) Extinguishing the stove fully
1
From any heat setting or the permanent
pilot, depress control knob fully and turn
clockwise to 'OFF' position.
57767
