Connections
The SDI video input and output is connected to the corresponding 75
made to the LC connector as indicated on the module. An example of a
LC connector shown below.
Operation
ed and received. Operation is
automatic, no user settings are required. For transmission, the SDI
video format is automatically detected, re-clocked and then
detected automatically, re-clocked and output as an electrical SDI
signal.
The OBD 1810-2 supports any SDI video signal from 270Mbit/s to 3Gbit/s.
Max distance is approx. 10km (6.2 miles). Data send and receive activity
is indicated by the LEDs located on the side of the module. The module
supports hot swapping and hot plugging of connections.
Power
The module requires a 12V DC power input and a LED is provided to
applying your own power, please provide a clean 12V DC power source.
Module power consumption is approx 250mA (2.8VA)
Power Lead Strain Relief
The module has a small hole in the case located above the power
connection to prevent the power lead being accidentally pulled out.
Use the supplied tie-wrap and secure the lead as shown below.
Note
:
OBD 1810-2 is identical in terms of mounting and securing.
Optional Mounting Bracket
The optional RFR 1001 mounting bracket can be used to permanently
The OBD 1810-2 LC is a bidirectional transceiver which can send and
receive
SDI data simultaniously through a single fiber link
. The
modules are supplied as pairs, one “
Type A
“ and one “
Type B
“ and must
be used as a pair. This is a closes loop WDM application using 1310 and
1550nm wavelengths.
