7
EN
6.a
6.c
7.a
7.b
7.d
7.c
6.b
Installing the rear wheel
Release the brake cable from the guide
(
1
). Put the wheel in one of the two fork
dropouts (see 6.b, 6.c.) then centre the
wheel and tighten the quick release
mechanism (
2
).
Two-position rear fork enables you to
adjust the height of the footrest above
the ground. Use the lower position
for riding over a rough terrain. Close
the quick release lever. It should point
upwards.
The upper fork position, which reduces
the height of the footrest, is designed for
riding on a smooth, flat surface. Riding
will be less physically demanding. The
closed quick release lever should point
downwards.
Adjusting the height of the handlebars
Loosen the screws on the stem and
adjust the handlebars to the desired
height using spacer rings. To set the
handlebars to the lowest position,
turn the stem so it points downwards,
see fig. 7.c. After adjusting the handlebar
height, first tighten the head-set screw
(
1
), then the side screws (
2
,
3
).
1
1
2
2
3
5–6 Nm
6–8 Nm
Summary of Contents for ALLOY Series
