- 16 -
Procedure (fuel adjustment, ignition timing correction, and
adjustment of RAM-pressure fuel correction volume)
1.
Transfer to F0 mode
Keeping both the “SELECT” and “RESET” buttons pressed simultaneously, turn
on the main switch.
“F0 ” appears in the display area at the bottom RHS of the meter.
2.
Transfer to the ECU applicable mode
Keeping both the SELECT and RESET buttons pressed simultaneously. “F1”
appears in the display.
3.
Selecting and confirming the applicable mode
When the SELECT or RESET buttons are simultaneously pressed, the display
shows the next application or reverts to the previous mode.
Keeping them pressed down allows the display to go step by step to the next
mode or to revert to the previous mode.
F1
⇔
F2
⇔
F3
⇔
F4
⇔
F5
⇔
F6
⇔
F7
⇔
F8
⇔
F9
⇔
FA
⇔
FB
⇔
FC
⇔
FD
⇔
FE
⇔
F1
When the mode you want to change appears, simultaneously press the SELECT
and RESET buttons in order to conform the desired mode.
4.
Changing and confirming the applicable value
When confirmation is made, “FX_YY” appears in the display.
YY indicates the applicable value and “ 0” the standard value.
For fuel volume correction, % is shown and for ignition timing correction, the
timing angle is shown.
To change the “YY” value, press the SELECT or RESET buttons and change the
numerical value.
To confirm the changed value and to transfer to another mode, simultaneously
press the SELECT and RESET buttons.
The value “YY” disappears from the display area in preparation for the
adjustment mode to be switched.
5.
Finishing the adjustment mode
Turn off the main switch, and the adjustment mode will end.
D.
Initialization of Value Changed
FE: Keeping the SELECT and RESET buttons simultaneously pressed, the transition
to this mode brings about initialisation.
“FE_YY” is shown in the meter screen. The numerical value “YY” represents the
value of each of the 13 modes from F1 to FD, but since it does not indicate which
mode has been changed, it is necessary to transfer to the adjustment mode in
order to check.
If “ 0” is displayed, it indicates an absence of changes and no initialisation is
needed. Turn off the main switch to end
