Installation_Guide | 1 - Installation Guide | 14
Rear Panel
Table 10: Descriptions of S300 Rear Panel
LED
Indication
Status
Description
On
The power is switched on.
POWER
Power status
Off
The power is switched off.
Blinking
The system is running properly.
SYSTEM
System
status
Static/Off
The system goes wrong.
Port
Description
WAN/LAN
Yeastar S300 provides two 10/100/1000Mbps adaptive RJ45 Ethernet ports, and
supports 3 Ethernet modes. The default mode is “Single”.
•
Single
: LAN port will be used for uplink connection. WAN port is disabled.
•
Bridge
: LAN port will be used for uplink connection. WAN port will be used as
bridge for PC connection.
•
Dual
: Both LAN and WAN ports can be used for uplink connection.
SD
Insert SD card to store auto recording files.
Reset button
Press and hold for 10 seconds to restore the factory defaults.
USB
Insert USB device to store auto recording files.
Console
Connect RS232 line to debug the system.
Power Switch Press this button to switch on/off the device.
Power Inlet
Connect the supplied power supply to the port.
