MyPBX U510 Installation Guide
http://www.yeastar.com 15/17
4.3 Network Settings
After logging in the admin configuration interface, generally the first step is to configure the IP address. If
both the WAN and LAN ports are connected to the network, their IP addresses need to be configured. If not,
just configuring the IP address of the LAN port which is connected to the local area network of the company
is OK.
WAN Settings
Click “Network Preference”->”WAN Settings” on the left menu bar.
1.
If the network that the WAN port is connected to is using DHCP server as connection method, please
select the “DHCP” (dynamic IP) option.
2.
If the network connection method is “Static IP address”, please select this option and enter the WAN
parameters (IP address, subnet mask, default gateway, DNS, etc.)
3.
If MyPBX is connected to ADSL adapter directly, please select “PPPoE” option and enter the ADSL
user name and password.
LAN Settings
Click “Network Preference”->”LAN Settings” on the left menu bar of the web configuration interface.
LAN port is used for the interoperability of IP terminals and MyPBX. If the LAN port is connected to the
company’s LAN, please configure the correct IP address and corresponding subnet mask.
Please note that after changing the IP address of LAN port, MyPBX should be rebooted to make the new
changes take effect.
4.4 Extensions Setup and management
MyPBX has already set up 6 extensions which are extensions “300-305” by default. The password is “pincode
+ extension number”. It’s up to the user to decide whether to directly use these default extensions or after
changing the password. Of course, they could be deleted.
The admin could add, edit or delete the extensions via the Web Configuration Panel.
In the “FXS/VOIP Extensions” page, there are “Add Extension”, “Add Bulk Extensions”, “Delete the Selected
Extension” and “Edit Extension”(configure the features such as call forwarding and voicemail) subpages, etc.
4.5 Configuring Terminals
MyPBX could be connected with SIP-based audio and video IP terminal devices (e.g. IP Phone, voice gateway,
and soft terminal, etc.). The steps of configuring terminals are as below:
Step 1: Make sure the IP terminal and MyPBX are interconnected
Step 2: Enter the IP address of MyPBX when configuring “SIP server”, “Proxy server”, or “Registration server”
of the IP terminals, and the default SIP UDP port is 5060.
Step 3: Enter the account registration information with the “extension number/password” of the default or
newly setup extensions of MyPBX.
For more information on terminal configuration, please refer to
http://www.yeastar.com/Solutions/SIP_Phones.asp
Step 4: Reboot the IP terminal after configuration, and click “Status”-> “Line Status”-> “Extension Status”on
the menu bar of MyPBX web configuration interface to check if it has registered successfully to MyPBX.
