5
●
Do not place heavy objects on the power cord.
The damaged power cord may cause fire or electric shock.
●
Before connecting a cable, turn off the power switch and disconnect the power cord from
outlet.
Malfunction of the device may occur.
●
To transport the device, use the special packing materials to protect the device from impact of
dropping.
Excessive vibration or impact to the device may cause malfunction.
●
In installation and operation of the device, observe the following instructions about EMC
(electromagnetic compatibility):
—
Do not use the device simultaneously with other electronic equipment to avoid
electromagnetic interference with the operation of the device.
—
Do not use the device near, on, or under other electronic equipment to avoid electromagnetic
interference with the operation of the device.
—
Do not use the device in the same room with other equipment such as life-support equipment,
other equipment that has major affects on the life of the patient and results of treatment, or other
measurement or treatment equipment that involves small electric current.
—
Do not use the device simultaneously with portable and mobile radio frequency
communication systems because it may have an adverse effect on operation of the device.
—
Do not use cables and accessories that are not specified for the device because that may
increase the emission of electromagnetic waves from the device or the system and decrease the
immunity of the device to electromagnetic disturbance.
●
The Electromagnetic Compatibility Directive sets the essential requirements for electrical and
electronic equipment that may disturb, or be disturbed by, other equipment. The CCQ-800
complies with these requirements. Follow the guidance in the tables for use of the device in an
electromagnetic environment.
●
Ground wire should be installed indoor and the instrument should be grounded well.
●
The instrument should not be installed in place where disconnection is not possible.
2.2 Using
●
Immediately replace the power cord if the internal wires are exposed, turns on or off the table
when the power cord is moved, or the cord and/or plug are too hot to be held with hands.