Registering
Register status icons on the touch screen
:
Registered
Register Failed
(Green)
(Gray)
(Green and Flashing)
3
Configuring Your Phone
Configuring via web user interface
Accessing the web user interface
:
1. Press the
OK
key when the phone is idle to get the IP address of the phone.
2. Open the web browser of your computer, enter the IP address into the address bar (e.g., "http://192.168.0.10" or
"192.168.0.10"), and then press the
Enter
.
3. Enter the user name (default: admin) and password (default: admin) in the login page and click
Confirm
.
Configuring via phone user interface
Network Settings
:
When the phone is idle, tap ->
Advanced Setting
(default password: admin)->
Network
->
WAN Port/VLAN/Web Server/802.1x/
VPN/ LLDP
to configure the network.
Account Settings
:
When the phone is idle, tap ->
Advanced
Setting (
default
password: admin)->
Accounts
to configure the account.
Note:
Check with your system administrator if any error appears during the registration process or if a specific
configuration is required for your registration.
Note:
The wrong network settings may result in inaccessibility of your phone and may have an impact on the network
performance. Contact your system administrator for more information.
Account Settings
: Click on
Account
->
Register
->
Account
X
(X=1,2,3...15,16)
Parameters of the account:
Register Status:
Line Active:
Label:
Display Name:
Register Name:
User Name:
Password:
Server Host:
It is provided by ITSP for registration (required).
It is provided by ITSP for registration (required).
It is authenticated ID for authentication provided by ITSP (required).
It is shown as Caller ID when placing a call.
It is shown on the touch screen to identify the account.
You can select Enabled/Disabled to enable/disable the account.
It shows the register status of the current account.
Note:
For more information on account parameters, refer to
Configuring via web user interface
.
Network Settings
: Click on
Network
->
Basic
->
IPv4 Config
You can configure the network settings in the following ways:
DHCP
: By default, the phone attempts to contact a DHCP server in your network to obtain tis valid network settings,
e.g., IP address, subnet mask, gateway address and DNS address.
Static IP Address
: If your phone can not contact a DHCP server for any reason, you need to configure the IP address
subnet mask, gateway address, primary DNS address and secondary DNS address for the phone
manually.
PPPoE
: If you are using an xDSL modem, you can connect your phone to the Internet via PPPoE mode. Contact the
ITSP for the PPPoE user name and password.
It is provided by ITSP for registration (required).
The IP phone also supports IPv6, but IPv6 is disabled by default.
