Yealink DECT Phone System Deployment Guide
6
This chapter describes how to choose appropriate locations for base stations and
repeaters on different sites. The purpose of this chapter is to familiarize you with the
procedures that are needed to carry out a site plan.
The following equipments are required for the deployment:
Base Station
Handset
Repeater
The following explains the procedures required to identify the quantity and position of
the base stations at prospective customer sites.
Note
When deploying in a single floor building (the width of the building is less than 100
meters), the deployment process consists of the following steps:
Identifying initial critical points on the floor plan
A critical point is a place that can be difficult for the radio signal to reach, such as a
corner of a room, lifts and stairwells. Determine the critical points for placing the
deployment base stations.
1.
Select the first critical point located in the corner furthest from the center areas
of the premises. Name this point P1.
2.
Select a nearby critical point adjacent to the first one and name it P2.
Locating the area center of the first base station
1.
Place the deployment base stations on the critical points.
2.
Set up communications between base stations and cordless handsets.
3.
Measure the radio coverage and determine the limit of the radio coverage of
two critical points.
4.
Determine the intersection point of the boundary lines of different radio
coverage cells. An intersection point will indicate the possible best location for
The following figures do not consider building elements that may influence the signal
strength.
Summary of Contents for Telkom W52P
Page 1: ......
