User Guide for the SIP-T27G IP Phone
130
Press , or the
Send
soft key to dial out.
-
If
Allow Trans Exist Call
(refer to
on page
) is enabled, you
can select the
New Call
and repeat steps mentioned above to complete transfer.
3.
After the party answers the call, press or the
Transfer
soft key to complete the
transfer.
If you are using a handset, the transfer can be completed by hanging up the handset.
You can cancel the transfer before the call is connected by pressing the
Cancel
soft key.
Call Waiting
You can enable or disable call waiting on the phone. If call waiting is enabled, you can receive
another call while there is already an active call on the phone. Otherwise, another incoming call
is automatically rejected by the phone with a busy message when there is an active call on the
phone. You can also enable or disable the phone to play a warning tone when receiving another
call.
To configure call waiting via phone user interface:
1.
Press
Menu
->
Features
->
Call Waiting
.
2.
Press or , or the
Switch
soft key to select
Enabled
from the
Call Waiting
field.
3.
Press or , or the
Switch
soft key to select
Enabled
from the
Play Tone
field.
4.
(Optional.) Enter the call waiting on code or off code respectively in the
On Code
or
Off
Code
field.
If on code or off code is configured, the IP phone will send the corresponding code to
activate or deactivate call waiting on the server. It is not available on all servers.
5.
Press the
Save
soft key to accept the change or the
Back
soft key to cancel.
Call waiting is configurable via web user interface at the path
Features
->
General Information
.
Note
If on code or off code is not configured, the call waiting may not take effect. It depends on your
server. Contact your server administrator for more information.