7
ASSEMBLY - SETUP
UNPACKING:
Carefully remove the mower from its packaging and check that
you have all the following items:
Upper Handle complete
(2) Lower Handle tubes (red)
Mower Bag and Mulch Plug (installed on the mower)
Tool kit
Engine Owner’s Manual and Warranty Statement
Bravo 21 Operator’s Manual.
NOTICE:
If you are missing any of these items or if you are unsure of
how to properly assemble this mower please contact
Ybravo.
com
by e-mail or by phone:
888.ybravo1
(888.927.2861)
Tools needed for assembly:
2 pcs 10mm wrenches
1 pcs 13mm wrench
1 pcs Needle nose pliers
STEP 1
Install the red handle tubes to the mower with the M8 carriage
bolts. Do not tighten the screws. Please note that there are
two holes for the upper clamp. We suggest to install the screw
in the lower hole as a start.
I
nstall the right side front
screw and insert the
mulch plug to hold the
screw during installation.
I
nstall the nuts fi nger tight.
Tighten completely
in step 3.
Needle Nose
Pliers
10 mm
13 mm
10 mm
STEP 2
Slide the upper handle assembly into the two lower tubes.
Insert the two carriage screws and use one square washer on
each side of the handle tube.
STEP 3
To simplify the alignment of the handle, install the grass
catcher.
Tighten the screws in the following order:
1 - Tighten the two screws on the right side tube clamps
2 - Align the left tube with the catcher (same as the right side)
and tighten the clamps.
3 - Tighten the upper screws that attach the handle assembly
to the tubes.
1
2
3
Summary of Contents for BRAVO 21- 201 BBC
Page 14: ...14 NOTES...
