Bluetooth instructions
Your
has a built-in CSR8675 bluetooth V5.0 module. Supports high quality music output.
IA350 MKII
Switch the
source to "BT" status.
IA350 MKII
After selecting "BT" ensure your device (i.e. phone or tablet) has Bluetooth switched on. It will show
YBA IA350
. Select this on your device and it will pair with the YBA IA350
.
MKII
MKII
When the device is connected, use the playback software to play music.
The
has an integrated Bluetooth aerial which provides greater transmission distance.
IA350 MKII
L
R
OUTPUT
V
Hz
W
N
320
L
R
PRE OUT
VIDEO
CD
COAXIAL OUT
AES/EBU
USB
XLR
I N T E G R A T E D A M P L I F I E R
Designed in France
COAXIAL
2
I S
DIGITAL POWER
ON
OFF
BT ANT
P A S S I O N I A
350
M K I I
Passion IA350 MKII Integrated Amplifier
www.ybahifi.com
Discovering your IA350 MKII: Rear view
CAUTION:
Before connecting or disconnecting any input or output:
4
Digital output: The IA350 MKII is equipped with one S/PDIF (75
Ω
) COAXIAL digital output, in order to
send digital signals to a digital recording device or external D/A processor.
Balanced Audio input: This is a higher quality input which can reject noise and interference in the cable
when used with equipment with balanced outputs. XLR connectors should be wired: Pin 1 - Ground;
Pin 2 - Hot (in-phase); Pin 3 - Cold (phase-inverted).
6
RCA Audio inputs: Connect the RCA outputs of your source to the RCA inputs of your IA350 MKII. Be
sure to connect the RIGHT output of your source to the R input of your amplifier and the LEFT output
to the L input of your amplifier. Your IA350 MKII allows the connection of 2 external line level sources.
Note: The VIDEO input has a Bypass feature. When you choose the VIDEO input, if you press < > OK
on the remote in sequence, the pre-amp will be enter Bypass status. When you press < > OK buttons
on the remote again, the unit will restore to "VIDEO" input status.
3
2
5
Page 7
4
9
5
8
2
Always make sure your
MKII is in the OFF position. If you
the power inlet.
IA350
have any doubt, unplug the AC cable from
Make sure all components connected to your amplifier are set to off.
Neatly
Separate AC wires from audio cables to prevent hum or other unwanted noise from being introduced into
the system.
arrange and organize wiring to and from your IA350 MKII and to and from all your components.
Digital input: The IA350 MKII is equipped with one S/PDIF (75
Ω
) COAXIAL digital input, USB
(PCM32/768KHz, DSD512) and AES/EBU, I S to receive digital signals from separate digital components.
2
Should you wish, you can disconnect power to the digital section of your IA350 MKII when using an
analogue source. Remember to re-engage this switch when using any digital input.
1
3
6
7
1
