YATO YT-83037, Original Instructions Manual, Page: 9 / 68

9
O R I G I N A L I N S T R U C T I O N S
GB
PROPERTIES OF THE PRODUCT
The recti fi er is a device that permits to charge any kind of batteries. The recti fi er converts the current and voltage in the power
network so as to guarantee a safe charging of batteries. Charging facilitates a proper functioning of a battery, which signi fi cantly
extends its life. The recti fi er is equipped with a short-circuit protection and an overcharge protection. A correct, reliable and safe
functioning of the device depends on its proper use, so:
Before you proceed to operate the device, read the manual thoroughly and keep it.
The supplier will not be held responsible for any damage resulting from the safety regulations and the recommendations indicated
hereby not being observed.
The indicators in the housing of the device are not meters, as the notion is construed in the „Measurement Act”
TECHNICAL DATA
Parameter Measurement unit Value
Catalogue number YT-83037
Power network voltage [V a.c.] 220 - 240
Power network frequency [Hz] 50 - 60
Rated current [A] 2,5
Rated charging voltage [V d.c.] 12
Charging current (voltage range) [A] 2 / 6 / 10 / 15 / BOOST - 20
Battery’s capacity [Ah] 2 - 300
Insulation class II
Protection grade IP20
Mass [kg] 2,1
GENERAL SAFETY CONDITIONS
The device has not been designed to be used by persons (including children) of impaired
physical, sensory or mental capabilities, or those who lack the necessary experience and
knowledge, unless they are supervised or they have been trained in operation of the device
by the safety personnel.
Preclude children from playing with the device.
The recti fi er has been designed to charge exclusively lead-acid accumulators. Charging any
other type of accumulators may lead to an electric shock, which is dangerous for health and life.
It is prohibited to charge non-rechargeable batteries!
During charging the accumulator must be placed in a well ventilated area. It is recommended
to charge the accumulator at a room temperature.
The recti fi er has been designed to be operated in interiors, and it is prohibited to expose it to
humidity, including atmospheric precipitation.
Electric Insulation Class I recti fi ers must be connected to sockets equipped with a protection
conductor.
While charging accumulators in the electric system of a car, fi rst the terminal of the recti fi er
must be connected to the terminal of the accumulator, which is not connected to the chassis
of the vehicle, and then connect the other terminal of the recti fi er to the chassis away from the
accumulator and the fuel system. Then connect the plug of the recti fi er to the power supply
socket.
Once the accumulator has been charged, disconnect the plug of the recti fi er from the power
supply socket, and then disconnect the terminal of the recti fi er.