YATO YT-82451, Manual, Page: 7 / 36

7
GB
O P E R A T I N G M A N U A L
PROPERTIES OF THE TOOL
The soldering tool has been designed for the purpose of soldering metals with tin and lead binders for soft soldering. A correct,
reliable and safe functioning of the tool depends upon appropriate operation, and therefore:
Before work with the tool, read the complete instruction and keep it.
The supplier will not be held responsible for any damage and injuries which occur as a result of inappropriate applications of the
tool, failure to observe safety regulations and the recommendations speci fi ed in these instructions. Improper application of the tool
will also cause cancellation of any guarantee rights due to incompliance with the sales contract.
EQUIPMENT
The soldering tool is provided complete and has additional accessories: spare soldering tips, rosin and soldering tin.
TECHNICAL DATA
Parameter Unit of measurment Value
Catalogue number YT-82451
Rating voltage [V~] 230 - 240
Rating frequency [Hz] 50
Paring power [W] 200
Tip temperature [
O
C] 70 - 200 / 201 - 350 / 351 - 500
Work mode S2 20% 12s / 48s
Dimensions (length x width x height) [mm] 185x185x55
Weight [kg] 0,92
Electric insulation class II
SAFE OPERATION INSTRUCTIONS
It is prohibited to use soldering gun with a worn-out soldering tip.
It is prohibited to touch insulation of electric conductors with a hot soldering tip.
It is prohibited to use the soldering gun under high humidity conditions and in explosive and
caustic gases and powders atmospheres.
Do not repair damaged electric conductors of the tool. In case the electric cord of the
device is damaged, it must be replaced with a new one. The power supply cord must
be realised by a quali fi ed electrician.
Do not solder live elements!
This appliance is not to be used by children or persons with reduced physical, sensory or
mental capabilities or lack of experience and knowledge if they have been given supervision
or instruction concerning use of the appliance in a safe way and understand the hazards
involved. Children shall not play with the appliance.
GENERAL SAFETY CONDITIONS
NOTE! Get acquainted with all the instructions below. Failure to observe them may lead to an electric shock, fi re or injuries. The
notion of electric tool used in the instructions applies to all the tools which are powered with electric current, both wire tools and
wireless ones.
OBSERVE THE FOLLOWING INSTRUCTIONS
Place of work
The place of work must be properly illuminated and clean. Disorder and poor illumination may be a cause of accidents.
Do not work with electric tools in explosive environments, or those which contain in fl ammable liquids, gases or vapours.
Electric tools generate sparks, which may cause a fi re in case of contact with in fl ammable gases or vapours.
Do not allow children and outsiders to the place of work. A lack of concentration may result in a loss of control over the tool.