Installation and Operation Guide SOLECTRIA® PVI 25TL-208, PVI 50TL-480 and PVI 60TL-480
DOCR-071030-A (10/7/2022)
Page 71 of 131
Neutral Line Setting
No
Yes
Figure 5-3 Setting the Neutral Line
Choosing the communication data. From the previous menu, press
ESC
to return to the System
Parameters menu. Scroll to Communication Setting and press
ENT
. Select Baud rate and press
ENT
. The
default setting is 9600. Depending on the data acquisition/SCADA system being used, the baud rate may
need to be increased or decreased. Scroll up/down to select other speeds and press
ENT
.
Next, select Address
and press
ENT
. This designates the inverter address. Each inverter within the Modbus
network must have a unique address (Unit ID). Scroll up/down to choose an address for the inverter and
press
ENT
. Addresses can be assigned from 1-128. See Figure 5-4.
Communication Setting
Baud rate
:
9600
Address
:
0001
Figure 5-4 Communication Setting
Setting the LCD contrast grade. From the previous menu, press
ESC
to return to System Parameters menu.
Select LCD Contrast Setting and press
ENT
. Using the up/down arrows increase or decrease the contrast
to the desired setting. Press
ENT
to accept the changes.
When the LCD screen shows the normal operation status Figure 5-5 and the “RUN” light on the LED panel
is illuminated, this is an indication that the grid connection and power generation were successful.
E-T:0.0kWh
2015-10-22 12
:
00:00
E-D:0.0kWh
3
6
9
12
15
18
21
24h
15
30
45
60
kWh
Standby Addr:001
PV1:0.0V 0.0A