18
YASKAWA
SIEP C730600 86F MECHATROLINK-II Technical Manual
A - Option
B - Included screws
C - Connector CN5-A
Figure 5.13 Insert the Option
5.
Firmly connect the MECHATROLINK-II communication cable to option communication connector CN3.
Isolate the communications cables from main circuit wiring and other electrical and power lines. Ensure
the cable end is firmly connected (see
). Refer to
MECHATROLINK-II Communications Cables
for more information.
Note:
Maximum transmission distance is 100 m (328 ft). Minimum wiring distance between stations is 0.2 m (7.9 in).
6.
Reattach the LED Status Ring board (E). Use the open space provided inside the LED Status Ring board
to route option wiring. Reattach the drive front cover (C) and the keypad (D).
Refer to the manual packaged with the drive for information about how to reattach the LED Status Ring
board.
NOTICE
Do not pinch cables between the front cover or the LED Status Ring board and the drive. Failure to
comply could cause erroneous operation.
Note:
• Replace the keypad connector then install the keypad.
• At that time, insert the keypad connector tab into the drive.
A - Keypad connector tab
B - Keypad connector
C - Drive front cover
D - Keypad
E - LED Status Ring board
Figure 5.14 Replace the Front Cover and Keypad
7.
Set drive parameters in
MECHATROLINK Option Drive Parameters on page 19
for correct option
performance.
◆
MECHATROLINK-II Communications Cables
Connect the MECHATROLINK-II communication cable to option communication connector CN3.
Use only these MECHATROLINK-II dedicated communications cables:
Recommended communication cables
•
JEPMC-W6002-xx-E
•
JEPMC-W6003-xx-E (with a core)
