The wiring happens without a tool.
Determine according to the casing labelling the connection position and insert
through the round connection hole of the according contact your prepared wire until
it stops, so that it is fixed.
ð
By pushing the contact spring opens, thus ensuring the necessary contact pres-
sure.
The wire is to be removed by means of a screwdriver with 2.5mm blade width.
1.
Press with your screwdriver vertically at the release button.
ð
The contact spring releases the wire.
2.
Pull the wire from the round hole.
CAUTION!
To protect the power supply lines, you should use a circuit breaker with
the following characteristics:
–
Rated current at AC 230V: 4A
–
Tripping characteristic: C
2.6 Demounting
By means of a screwdriver there is the possibility to remove the connectors e.g. for
module exchange with a fix wiring. For this each connector has indentations for unlocking
at the top. Unlocking takes place by the following proceeding:
1.
Remove connector:
Insert your screwdriver from above into one of the indentations.
Insert wire
Remove wire
Fusing
Remove connector
VIPA System MICRO
Basics and mounting
Demounting
HB400 | PS | M07-2BA00 | en | 20-02
16
