8-1
179394-1CD
HW1483905
8
Electrical Equipment Specification
8.1 Location of Broken-Belt Detection Sensors
MFL15D-875/-1600
8
Electrical Equipment Specification
8.1
Location of Broken-Belt Detection Sensors
The broken-belt detection sensors are installed only on the U-axis. Refer
to
Fig. 8-1 “Location of the Broken-Belt Detection Sensor”
Fig. 8-1: Location of the Broken-Belt Detection Sensor
NOTE
If a message for a broken belt appears, remove the cover
on the U-arm, and check if the belt is broken. If this
message appears, take the same corrective action as for an
overrun recovery as described in the DX200 Operator’s
Manual.
Replace the broken belt promptly in the event that the belt is
broken.
Two broken-belt detection sensors are
mounted inside the Z(U)-axis (up/down) arm.
47 of 74
