3.2 PS M07 DC24V, 1.5A_AC120V-240V
n
Output current 1.5A
n
Rated output voltage DC 24V
n
Connection to single-phase AC mains wide-range input AC 120...240V without
manual switching
n
Protection against short circuit and overload
n
Can be used together with System MICRO on the rail
n
Safe electrical isolation according to EN 60950
n
Overtemperature protection
n
Efficiency typ. 90% at I
nominal
n
Can be used as electronic and power section supply
Type
Order number
Description
PS M07 DC24V, 1.5A_AC120V-240V
M07-2BA00
Power supply
primary AC 120...240V, secondary DC 24V,
1.5A
1
X1: Terminal DC 24V output
2
X3: Terminal AC 120-240V input
3
Status bar power module
Schematic diagram
CAUTION!
–
The power supplies must be released before installation and repair
tasks, i.e. before handling with the power supply or with the cabling
you must disconnect current/voltage (pull plug, at fixed connection
switch off the concerning fuse)!
–
Installation and modifications only by properly trained personnel!
Status bar
LED
Description
LEDs off: Input voltage too low, power supply does not start.
LEDs green on: OK: There is no fault and the DC 24V power supply is ensured.
LED red on: Overload: The module is overheated or overloaded (short circuit).
Properties
Ordering data
Structure
VIPA System MICRO
Power supply
PS M07 DC24V, 1.5A_AC120V-240V
HB400 | PS | M07-2BA00 | en | 20-02
24
