1.2 Mounting/Removing Optional Modules on Machine Controller
19
1
2.
Remove the panel of Optional Module.
Insert the protruding part of the battery cover into the slot on top of the panel of Optional Module to unhook, as
shown in the diagram. Face the front of the battery cover towards you for this operation.
Unhook the bottom in the same way.
3.
Remove the Optional Module from the mounting base.
Pull the top of the panel of the Optional Module towards you to remove it. A notch on the Optional Module will
be visible from the gap in the cover. Hook the round knob on the battery cover, shown in the diagram, into the
notch in the Optional Module.
Hold the center of the battery cover as shown in the following diagram. Push the battery cover down and out,
rotating from the round knob to disconnect the Module and mounting base connectors, and then pull the Optional
Module forward.
Round knob
Notch
Fulcrum
