YASKAWA GA80U Series, Installation & Primary Operation, Page: 92 / 168

12 UL Standards
92 YASKAWA TOEPC71061737D GA800 DRIVE INSTALLATION & PRIMARY OPERATION
◆
Wire the Main Circuit Terminal Block
Wire the main circuit terminal block correctly as specified by the instructions in the manual.
To comply with UL standards on drive models 2257 to 2415, 4208 to 4H12, and T208 to T720, use UL Listed closed-
loop crimp terminals. Use the tools recommend by the terminal manufacturer to crimp the closed-loop crimp terminal.
Refer to
Closed-Loop Crimp Terminals on page 92 for more information about UL Listed closed-loop crimp
terminals.
To select the correct wire gauge, refer to Three-Phase 200 V Class on page 38 and Three-Phase 400 V Class on page
42 .
◆
Closed-Loop Crimp Terminals
To comply with UL standards on drive models 2257 to 2415, 4208 to 4H12, and T208 to T720, use UL Listed closed-
loop crimp terminals and heat-shrinkable tubing. Use the tools recommend by the terminal manufacturer to crimp the
closed-loop crimp terminal. Yaskawa recommends closed-loop crimp terminals and heat-shrinkable tubing from
PANDUIT Corp.
Make sure that you comply with local standards for correct wire gauges in the region where you will use the drive.
Refer to Table 12.1 , Table 12.2 , Table 12.3 , and Table 12.4 to select crimp terminals as specified by drive model and
wire gauge.
Note:
To comply with UL standards, use only insulated crimp terminals or crimp terminals with insulation tubing. Use UL Listed vinyl-coated
insulated copper wires for operation with a continuous maximum permitted temperature of 75 °C at 600 V.
Table 12.1 Closed-Loop Crimp Terminals for Three-Phase 200 V Class Drives (Manufacturer: PANDUIT Corp.)
Model
Recomm. Gauge (AWG, kcmil)
Crimp Terminal
Model
*1
R/L1
S/L2
T/L3
U/T1
V/T2
W/T3
-, +1 +3
2004 - 2021 - - - - 10 P10-8R-L
2030, 2042 - - - - 8
P8-10R-Q
S8-10R-Q
2056 - - - - 6
P6-14R-E
S6-10R-E
2070 - 2110 - - - - 6
P6-14R-E
S6-10R-E
2138 - - - - 4
P4-14R-E
S4-56R-E
2169, 2211 - - - - 4
P4-56R-E
S4-56R-E
2257
2/0 × 2P 2/0 × 2P - - - S2/0-38R-X
- - 4/0 × 2P - - S4/0-38R-5
- - - 1/0 × 2P - S1/0-38R-X
- - - - 3 S2-38R-X
2313
4/0 × 2P - - - - S4/0-38R-5
- 3/0 × 2P - - - S3/0-38R-5
- - 250 × 2P - - S250-38R-5
- - - 1/0 × 2P - S1/0-38R-X
- - - - 2 S2-38R-X