YASKAWA GA800 Series, Programming Manual

Page: 577 / 644

Keypad
Use
and
T
est
Run
3
3.4 Keypad Operation
YASKAWA TOEPYAIGA8002B GA800 Drive Programming 577
3.
Push or to select [Initial Settings], then push .
4.
Push or to select [Language Selection], then push .
5.
Push or to select the language, then push .
The procedure to set the keypad language is complete.
◆
Set the Date and Time
The procedure in this section shows how to set the date and time.
Note:
• To set the drive to detect an alarm when the battery is dead or when the clock is not set, install the battery then set o4-24 = 1 [bAT Detection
selection = Enable (Alarm Detected)] .
•
If the keypad does not have a clock battery, you must set the date and time each time you energize the drive.
1.
Push (Home) to show the HOME screen.
Note:
• The keypad will show [Home] in the top right corner when the HOME screen is active.
• If [Home] is not shown on , push (Back) to show [Home] on .
2.
Push (Menu).