E-8
9
INSTALLING AN NS115 Module
This section describes the methods and the installation sites for mounting an NS115 Module on
a SERVOPACK.
Mounting of the NS115 Module
Mount an NS115 Module on a SGDH SERVOPACK in the following manner.
1. Remove the connector cover mounted on the CN10 of the SERVOPACK.
Mounting
Method
SERVOPACK Type
Screw
Remarks
Base
mounted
SGDH-A3 to 02BE
SGDH-A3 to 10AE
M3
×
10 round head screws
(with spring washer and
plain washer)
Use attached screws on the NS115 Module.
SGDH-15 to 50AE
SGDH-05 to 50DE
M4
×
10 round head screws
(with spring washer and
plain washer)
Use attached screws on the NS115 Module.
SGDH-60 to 1EAE
SGDH-60 to 1EDE
M4
×
8 round head screws
(with spring washer and
plain washer)
Use the screw of the front panel.
Rack
mounted
SGDH-A3 to 02BE-R
SGDH-A3 to 50AE-R
SGDH-05 to 50DE-R
M4
×
6 round head screws
(with spring washer and
plain washer)
Use attached screws on the NS115 Module.
Note: Make sure that spring washers and
plain washers are used for mounting.
(Otherwise, the screw for connecting
ground wire sticks out from the other
side of the flange, and the SERVO-
PACK cannot be mounted properly.)
Duct
ventilated
SGDH-60 to 1EAE-P
SGDH-60 to 1EDE-P
M4
×
8 round head screws
(with spring washer and
plain washer)
Use the screw of the front panel.
MODE/SET
DATA/
CHARGE
POWER
SGDH-
SERVOPACK
YASKAWA
CN10
SERVOPACK
Connector
cover
