14
MAINTENANCE
Servicing
Replacing the Scraper
Replacing the Rotor
Fig. 5
Fig. 8
Fig. 9
Fig. 7
Fig. 6
Screw
Screw
Right side cover
Short shaft
Servicing should be performed by a qualified technician. Replacement parts for this Snow Thrower must be identical
to the parts that they replace. If repairs are necessary, contact the Toll-Free Helpline, at 1-866-523-5218.
Note:
Identify the left and right sides of the Snow Thrower when standing in the normal operating position.
WARNING:
If the extension cord is plugged into the Snow Thrower,
the Snow Thrower could start
accidentally while the operator is performing maintenance on it, which could cause serious personal
injury.
Disconnect the extension cord before performing any maintenance.
The scraper is located at the bottom of the rotor housing,
as shown in Figure 5.
1. Remove the 5 screws that secure the scraper to the
Snow Thrower (Fig. 5).
2. Install the new scraper, and attach it securely using the
5 screws.
1. Remove the 4 screws that secure the right side cover to
the frame of the Snow Thrower (Fig. 6).
2. Remove the short shaft (Fig. 7).
3. Push the sides of the housing out, as illustrated in Figure 8
and remove the rotor (Fig. 9).
4. Install the new rotor, and reinstall the clip.
5. Reinstall the right side cover, and secure it using the 4
screws.
Summary of Contents for 60-3983-8
Page 18: ...EXPLODED VIEW PARTS LIST 18 ...
