Yardworks 274-1754-8, Instruction Manual

Page: 16 / 34

model no. 274-1754-8 | contact us: 1.866.523.5218 model no. 274-1754-8 | contact us: 1.866.523.5218
16
ADDING BAR AND CHAIN LUBRICANT
Use a bar and chain lubricant (not included) with this product. It is designed for chains and
chain oilers, and is formulated to perform over a wide temperature range with no dilution
required.
• Remove oil cap.
• Carefully pour the bar and chain oil into the tank.
• Wipe off excess oil. Replace oil cap.
• Check and fill the oil tank until the quick view oil indicator is below the second to last
indicator line.
• Repeat as needed.
Quick View
Oil Indicator
Oil Reser-
voir Cap
I
C
C I
R
!
NOTE: This pole saw comes from the factory with no
bar and chain oil added. The level should also be checked
after every 20 minutes of use and refilled as needed.
! NOTE: Do not use dirty, used or otherwise contaminated oils.
Damage may occur to the bar or chain.
!
NOTE: It is normal for oil to seep from the saw when not in use.
To prevent seepage, empty the oil tank after each use, then
run for one minute. When storing the unit for a long period
of time (three months or longer), be sure the chain is lightly
lubricated; this will prevent rust on the chain and bar sprocket.
!
IMPORTANT: To preserve natural resources, please recycle or
dispose of oil properly. Consult your local waste authority for
information regarding available recycling and/disposal options.
Oper
ating Instructions