model no. 060-2279-2 | contact us: 1.866.523.5218
model no. 060-2279-2 | contact us: 1.866.523.5218
21
Tr
oubleshooting
If your device is not operating properly, follow the instructions below. If this does not solve
the problem, please contact your local repair agent.
TOOL RUNS SLOWLY
•
Check that the spool housing can rotate freely. Carefully clean it if necessary.
•
Check that the cutting line does not protrude more than 4 1/2” (11 cm) from the spool
housing. If it does, cut it off so that it just reaches the line trimming blade.
AUTOMATIC LINE FEED DOES NOT WORK.
•
Press the tabs and remove the spool cover from the housing.
•
Pull the cutting line until it protrudes 4 1/2” (11 cm) from the housing. If insufficient cutting
line is left on the spool, install a new spool of cutting line as instructed in the Maintenance
section of this lowercase.
•
Align the tabs on the spool cover with the cutouts in the housing.
•
Push the cover onto the housing until it snaps securely into place.
•
If the cutting line protrudes beyond the trimming blade, cut it off so that it just reaches
the blade.
•
If the automatic line feed still does not work or the spool is jammed, try the following
suggestions:
•
Carefully clean the spool cover and housing.
- Remove the spool and check if the lever can move freely.
- Remove the spool and unwind the cutting line, then wind it on neatly again as
described above. Replace the spool as instructed.
!
WARNING: before proceeding, switch off and unplug.
