Yardworks 060-0583-8, Operator'S Manual

Page: 11 / 38

10
®
/MD
model no. 060-0583-8 | contact us: 1.866.523.5218
5. Clip the 2 chute
clean-out tool clips on
the side of the middle
frame, and insert the
chute clean-out tool in
the clips (Figs. 5 - 6).
6. Clip on the 2 cable
clips on the frame,
and insert the cable
inside of the cable
clips (Fig. 7).
DISCHARGE CHUTE ASSEMBLY
1. Loosen the knob to lift
the chute deflector.
2. Lift the chute deflector
and lock it securely
onto the discharge
chute.
3. Raise or lower the
chute deflector to
the desired height of
the snow stream and
tighten the knob.
NOTE! Do not
overtighten the knob.
CHUTE CRANK ASSEMBLY
1. Remove the cotter pin
from th lower chute
crank (Fig. 11).
2. Install the lower crank
rod by inserting it into
the opening at the
back of the housing
with holes aligned
(Fig. 12).
3. Secure the lower
chute crank in place
with the cotter pin
(Fig. 13).
4. Remove the
thumbscrew on the
crank rod connector
by hand (Fig. 14).
5. Slide the upper chute
crank through the
rubber ring located
on the middle frame
(Fig. 15).
6. Slide the upper
chute crank into the
crank rod connector
(Fig. 16).
7. Align the screw
holes and tighten the
thumbscrew by hand
(Fig. 17).
NOTE: Before using this machine, make sure that
the power source you will use complies with the
specifications detailed in this manual. Before inserting
the plug into the socket, verify that the snowblower’s
roll shaft and rubber plates are firmly secured with
screws, and that the rubber plates are facing the
correct direction. Perform a test run to ensure that the
rotor turns freely.
Assembly
Fig. 9
Fig. 10
Fig. 11
Fig. 5
Chute clean-out
tool clips
Fig. 11
Lower chute crank
Align the
holes
Fig. 12
Cotter pin
Fig. 13
Thumbscrew
Lower chute
crank
Crank
rod
connector
Fig. 14
Rubber ring
Upper chute crank
Fig. 15
Upper chute
crank
Crank rod
connector
Fig. 16
Thumbscrew
Chute clean-out
tool
Cable clips
Cable
Cotter Pin
Lower chute crank
Fig. 5 Fig. 12
Fig. 13
Fig. 14
Fig. 15
Fig. 16
Fig. 17
Fig. 6
Fig. 7
Fig. 8
Chute clean-out
tool clips
Align the
holes
Lower chute crank
Cotter pin
Crank
rod
connector
Thumbscrew
Lower chute
crank
Rubber ring
Upper chute
crank
Crank rod
connector
Thumbscrew
Upper chute
crank
Chute clean-out
tool
Cotter Pin
Lower chute crank
Cable clips
Cable