x2
2 x 3 x 7-7/8" (5,1 x 7,6 x20 cm)
TEMPORARY SUPPORT
DY
x11
7-1/4 x 18-1/4" (18,4 x 46,4 cm)
x12
2 x 4 x 68-7/16" (5,1 x 10,2 x 173,8 cm)
YJ
OSB OR WOOD GRAIN
31
Fit base of Rafters in corners
of back wall and jig.
PARTS REQUIRED:
x132
RAFTERS
FINISH
6
You have finished assembling your rafters.
Flip over rafter assembly and repeat STEPS 2-4 to attach second gusset to other side.
SET ONE RAFTER ASSEMBLY ASIDE WITH ONLY ONE GUSSET ATTACHED.
Repeat STEPS 2-4 to build three additional rafter assemblies. Remove
DY
.
Apply glue to rafters where gusset will fit.
NOTE: BE SURE TO SET ASIDE ONE GUSSET WITH FINISHED WOOD GRAIN PATTERN.
Secure gusset to rafters using twelve 2" (5,1 cm) Nails as shown.
4
5
3
2
107-1/8"
(272,1 cm)
Back Wall
YJ
Temporary
support DY
Temporary
support DY
YJ
Flush
Contact at peak
Flush
2" (5,1 cm)
You will build
SIX
assemblies.
(5) with two gussets, and (1) with one gusset.
Place two rafter halves (
YJ
) in the corner of back and side wall and
DY
.
Rafters contact at peak.
BEGIN
¸
1
Glue
Glue
Center
Gusset
Flush
2" (5,1 cm)
Nails
(12) per side
x2
HINT:
Use floor and walls to
help assemble rafters!
3" (7,6 cm)
Place one
DY
against back wall inner panel as shown. Position and
square other
DY
as temporary jig using two 3" (7,6 cm) screws as shown.
