Yardbeast YB2090, User Manual

Page: 8 / 27

8
change the engine governor settings, it can
get ouf of control and operate at unsafe
speeds and off-spec.
Never change the
factory settings of the engine.
Installation and Setup
Metal Cage Content:
1 Wood Chipper.
1 Feed chute.
1 Rear Axle.
1 Bag of nuts and bolts that includes:
Bolts, washers, nuts, cotter pins, etc.
2 Towing brackets
1 Tow Bar and accesories (pins, stand)
2 Turf Wheels
Manuals and Operator safety accesories.
Assembly of the YARDBEAST 2090
Note: This unit is shipped without fuel and
without oil in the engine. Fill with gasoline
(depending on the engine type) and oil as
indicated in the instructions in the engine
manual
BEFORE operating your wood
chipper.
Taking shipping cage off.
1. Remove plastic packing
2. Unscrew the ends of the cage as shown in
next Figure.
3. Remove upwards (use 2 people if
possible) as shown in next Figure.
4. Remove the chipper by removing the
platform anchor plates. See Fig . below.
Axle Assembly
1. Inserting rear axle to the chipper's base
and bolt it as shown in Fig. 1
Figure on next page..
a. 4 Hex Bolts 3/8 "x 1-1/2"
b. 4 Lock Nuts 3/8 "
c. 4 Flat Washers 3/8 "
Tools used: 9/16" hex wrench