6
4. Use work gloves with palm of leather or
industrial cotton when you feed the material
into the hopper. Before you turn on the
machine, check all bolts and accesories to
ensure that the machine is in safe operating
condition.
5. Perform a visual inspection of the
machine in frequent intervals to check
whether the chippers has suffered any
important damage.
6. Maintain and replace the safety labels
and instructions as necessary.
Safe Handling of Fuel
To avoid personal injury or property
damage, be very careful when handling
fuel. The fuel that is used, whether diesel or
gasoline is highly flammable and the vapors
are explosive. You can be seriously injured if
fuel if spilled on yourself and your clothes
which can ignite. Wash your skin and
change clothes immediately.
1.
Use only containers approved for
Gasoline or Diesel .
2.
Never fill containers inside a vehicle or
truck. Always place containers on the
ground away from your vehicle before
filling.
3 .
Keep the nozzle in contact with the
edge of the entrance to the engine fuel
tank or container at all times until it is full
at recommended engine manufacturer
specifications.
4 .
No smoking should take place. Turn
off all cigarettes, cigars, pipes and other
sources of ignition.
5.
Never refuel the machine indoors.
6
. Never remove gas cap or add fuel
while the engine is hot or running . Allow
engine to cool at least two minutes
before re- fueling .
7. Never overfill the fuel tank . Fill tank to
no more than 1/ 2 inch below the base
of the neck of the thread to allow room
for fuel expansion.
8. Place the fuel cap back on and
tighten securely .
9
.
Clean up spilled fuel on the engine
and equipment. Move machine to
another area. Wait 5 minutes before
starting the engine.
Operation of the Wood Chipper
1.
Check the oil and fuel level before
starting the engine.
2.
If the chipper will not be hitched to an
ATV, check that the trailer stand is firmly
tightened.
3.
Do not put hands near rotating parts
or power inputs . Contact with the
chipper and rotating parts –while in
operation- can serioulsy damage fingers,
hands .
4.
Before operating the machine , open
it. Check and clean the rotor of foreign
debris objects , make sure the cutting
chamber is empty and free of any
foreign material.
5. .
Thoroughly inspect all material to to
be chipped and remove any foreign
objects -such as nails, glass, steel wire,
etc- that could cause injury to you or
damage the machine.
6 .
Do not attempt to chop material
Summary of Contents for YB2090
Page 27: ...27 NOTES ...
