![background image](http://html1.mh-extra.com/html/yard-machines/820-thru-829/820-thru-829_operators-manual_3317785023.webp)
23
Figure 26
Dimension ‘‘B’’ should be approximately 1/16-5/16" less
than Dimension ‘‘A.’’ See Figure 27. To increase
Dimension ‘‘B,’’ screw tie rod into tie rod end. To
decrease Dimension ‘‘B,’’ unscrew tie rod from tie rod
end. Reassemble tie rod. Check dimensions. Readjust
if necessary.
Figure 27
BATTERY CARE AND MAINTENANCE
(TYPE "A" BATTERY)
Type “A” batteries are sealed and are maintenance
free.
BATTERY CARE AND MAINTENANCE
(TYPE "B" BATTERY)
CHECK FLUID LEVEL
Check fluid level inside each cell of the battery every
two weeks and before and after charging. Always keep
level just below the split rings.
Add only distilled water. Never add additional acid
or any other chemicals to the battery after initial
activation.
NOTE:
After operating the tractor for a long period of
time, check the fluid level in the battery as it can
overheat and lose fluid.
CHARGING THE BATTERY (All Batteries)
The engine is equipped with an alternator which
charges battery when tractor is operated. Under normal
conditions, the battery only needs to be charged before,
during and after off-season storage. Follow the
instructions under “Off-Season Storage.”
To charge the battery:
Battery P/N 725-1705D—
Charge at 2-3 amps for one hour. Battery P/N 725-
1707D, 725-0453G, 725-1750, and 725-1706—Charge
at 6 amps for one hour.
REMOVING / INSTALLING / JUMP
STARTING
WARNING: When removing or installing
the battery, follow these instructions to
prevent the screwdriver from shorting
against the frame.
Removing the Battery:
Disconnect negative cable
first, then positive cable.
Installing the Battery:
Connect positive cable first,
then negative cable.
Jump Starting
•
First, connect end of one jumper cable to the
positive terminal of the good battery, then the other
end to the positive terminal of the dead battery.
•
Connect the other jumper cable to the negative
terminal of the good battery, then to the FRAME OF
THE UNIT WITH THE DEAD BATTERY.
WARNING: Failure to use this procedure
could cause sparking, and the gas in
either battery could explode.
CLEAN THE BATTERY
Clean the battery by removing it from the unit and
washing with a baking soda and water solution. If
necessary, scrape the battery terminals with a wire
brush to remove deposits. Coat terminals and exposed
wiring with grease or petroleum jelly to prevent
corrosion.
BATTERY FAILURES
Some common causes for battery failure are: incorrect
initial activation, lack of water, adding chemicals other
than water after initial activation, undercharging,
overcharging, corroded connections, freezing.
These
failures do not constitute warranty.
Tie Rod
End
Hex Jam
Nut
Tie
Rod
Wheel
Bracket
Hex Nut
Lock Washer
A
B
Front
(1/16" - 5/16" Less Than A)