4
•
This unit does not have a clutch. The cutting
attachment continues to rotate when the engine
is idling. To prevent injury, have the unit adjusted
by an authorized service technician.
•
Adjust the D-Handle to your size to provide the
best grip.
•
Be sure the cutting attachment is not in contact
with anything before starting the unit.
•
Use the unit only in daylight or good artificial
light.
•
Avoid accidental starting. Be in the starting posi-
tion whenever pulling the starter rope. The opera-
tor and unit must be in a stable position while
starting. See Starting/Stopping Instructions.
•
Use the right tool. Only use this tool for the pur-
pose intended.
•
Do not overreach. Always keep proper footing
and balance.
•
Always hold the unit with both hands when oper-
ating. Keep a firm grip on both the front and rear
handle or grips.
•
Keep hands, face, and feet at a distance from all
moving parts. Do not touch or try to stop the cut-
ting attachment when it is rotating.
•
Do not touch the engine, gear housing or muffler.
These parts get extremely hot from operation.
When turned off they remain hot for a short time.
•
Do not operate the engine faster than the speed
needed to cut, trim or edge. Do not run the
engine at high speed when not cutting.
•
Always stop the engine when cutting is delayed
or when walking from one cutting location to
another.
•
If you strike or become entangled with a foreign
object, stop the engine immediately and check
for damage. Do not operate before repairing dam-
age. Do not operate the unit with loose or dam-
aged parts.
•
Stop and switch the engine to off for mainte-
nance, repair, or for changing the cutting attach-
ment or other attachments.
•
Use only replacement parts and accessories
approved by the manufacturer for this unit. These
are available from your authorized service dealer.
Use of any non approved parts or accessories
could lead to serious injury to the user, or damage
to the unit, and void your warranty.
•
Keep unit clean of vegetation and other materials.
They may become lodged between the cutting
attachment and shield.
•
To reduce fire hazard, replace faulty muffler and
spark arrestor, keep the engine and muffler free
from grass, leaves, excessive grease or carbon
build up.
OTHER SAFETY WARNINGS
•
Never store the unit, with fuel in the tank, inside a
building where fumes may reach an open flame or
spark.
•
Allow the engine to cool before storing or trans-
porting. Be sure to secure the unit while trans-
porting.
•
Store the unit in a dry area, locked up or up high
to prevent unauthorized use or damage, out of
the reach of children.
•
Never douse or squirt the unit with water or any
other liquid. Keep handles dry, clean and free
from debris. Clean after each use, see Cleaning
and Storage instructions.
•
Keep these instructions. Refer to them often and
use them to instruct other users. If you loan
someone this unit, also loan them these instruc-
tions.
SAVE THESE INSTRUCTIONS
WARNING – YOUR RESPONSIBILITY:
Restrict the use of this power machine to persons
who read, understand and follow the warnings and instructions in this manual and on the machine.
•
WARNING - READ OPERATOR'S MANUAL
Read the Operator’s Manual(s) and follow all warnings and safety instructions.
Failure to do so can result in serious injury to the operator and/or bystanders.
•
WEAR EYE AND HEARING PROTECTION
Thrown objects and loud noise can cause severe eye injury and hearing loss. Wear eye protection
meeting ANSI Z87.1 standards and ear protection when operating this unit.
•
KEEP BYSTANDERS AWAY
Keep all bystanders, especially children and pets, at least 50 feet (15 m) from the operating area.
