Yard force YF22ESSPV, Operator'S Manual

Page: 11 / 62

10
ASSEMBLY/ PRE-OPERATION
CAUTION: Read complete INSTRUCTION MANUAL before operating this machine.
IMPORTANT:
THIS LAWN MOWER IS SHIPPED WITHOUT OIL OR GASOLINE IN THE ENGINE.
Your new lawn mower has been assembled at the factory with the exception of those parts left
disassembled for shipping purposes. All parts such as nuts, washers, bolts, etc., necessary to complete the
assembly have been placed in the parts bag. To ensure safe and proper operation of your lawn mower, all
parts and hardware you assemble must be tightened securely. Use the correct tools as necessary to ensure
proper tightness.
SETUP
TO REMOVE LAWN MOWER FROM CARTON
1. Remove loose parts included with mower.
2. Cut down two end corners of carton and lay end panel down flat.
3. Remove all packing materials except padding between upper and lower handle and padding holding
operator presence control bar to upper handle.
4. Roll lawn mower out of carton and check carton thoroughly for additional loose parts.
HOW TO SET UP YOUR LAWN MOWER
IMPORTANT: Get out the handle carefully to avoid pinching or damaging the control cables.
1. Insert the lower handle to the two side brackets on the mower deck. Use corresponding holes on the
brackets when attaching lower handle pin for a suitable handle height desired. Fasten the lower handle
to the lawn mower by using handle bolts, install and tighten knobs to secure the handle. (Fig. 1 & 2)
NOTE: The washer should be pressed against the inner face of the bracket.
2. Attach the upper handle into place and attach it to lower handle by using handle bolts.
SETUP
fixing knob
Fig. 1
Fig. 2
raise
lower